Thanks! It actually the soldering itself wasn't much of an issue (except on those tiny motors wires where I had to scrape off the enamel and stuff), it was mostly just getting the wires to fit. I ended up having to de/resolder the wires one each ESC so they could press up closer to the corners of the stack. Things really start to get crowded when you go this small
Yeah it was a pain to make sure I didn't accidentally cut the wire itself. The props give me plenty of power but they are pretty loud, I'm looking forward to printing a cutter so I can try out the apparently quieter cut down ones.
Have fun with your motors! Amazing how brushless is able to compete with brushed now in terms of size
Looks great! How difficult was it to solder all those tiny wires?
Thanks! It actually the soldering itself wasn't much of an issue (except on those tiny motors wires where I had to scrape off the enamel and stuff), it was mostly just getting the wires to fit. I ended up having to de/resolder the wires one each ESC so they could press up closer to the corners of the stack. Things really start to get crowded when you go this small
The enamel sucks! I'm going to upgrade to some DYS motors sooooon. 10000kv whoooo!
How are those props btw
Yeah it was a pain to make sure I didn't accidentally cut the wire itself. The props give me plenty of power but they are pretty loud, I'm looking forward to printing a cutter so I can try out the apparently quieter cut down ones.
Have fun with your motors! Amazing how brushless is able to compete with brushed now in terms of size