betafpv 20a 4s 1304

By matthew saigon on Oct 21, 2019

3  405  0

10/21/19 note: if you're going to use 4s 1304, 1404 or bigger, you should use betafpv 20a. 12a esc won't give you enough output power. those setups still run fine but they feel less power than they should. even the motors draw less than 12a. ( trust me, forget 12a esc with those motors )

i just show my setup here, so i don't have to remember it.

weight: 86g dry
battery: 80g 4s , don't use 70g batteries. this thing sucks them down quick.
propeller: Avan 3025
motor: ldarc 1304 4100kv, ( i've heard rcx 1304 are better but i don't have them )
camera: runcam nano
vtx: hglrc nano ( tbs pro32 nano is better )
receiver: R-XsR
flight controller: BetaFPV 20a aio whoop board

PID is ok, flyable.
betaflight 4.1 ( PID is in the picture )
TPA: 0.70 breakpoint: 1250

10/24/19: i need to change out vtx. it's bad and makes me nervous. it flies pretty good. but i feel people are going to like them with 1404 or 1306.

Photos

Discussion

Sign in to comment

Guides & Reviews

39 3,806  46
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more
28 7,660  38
Nov 30, 2019

In late 2019 DJI made inroads into the FPV scene with their remarkable low-latency digital system. It gave us a 720p video feed with latency on-par with the status quo, analog video. Traditionally we've used analog video systems for low-latency video, but the video quality is far from ideal. It's a trade-off we've been willing to accept for the control. Now we've got the best of both worlds and what..

Read more