Mockup

TinyBrat

By morcmorc on Jun 03, 2020

0  0  0

My Ideal Tank Build

Merging the Acrobrat's clean dirty section with the modular arm design of the Glide frame.
Instead of Acrobrat's rubber grommets to decouple the clean section, I use the TPU system from the Colibri frame.
Cam board, rx and vtx are mounted to the clean section. Together with a 80g 4s 650mAh battery the clean section should be heavier than the dirty section.
Therefore vibrations should be transfered or stay within the dirty section.

38,0g Frame
06,6g AIO
44,0g Emax 1306 Motors + Wire
08,2g Props (2,05g x 4)
18,0g Runcam Hybrid
01,0g TBS Unify Pro32 Nano
01,5g r-xsr
05,0g Pigtail + cap
02,0g Antenna


124,3g
65,0g 4s 450mAh Battery


189,3g

Clean Section
12,5g Frame parts
01,0g TBS Unify Pro32 Nano
01,5g r-xsr
05,0g Pigtail + cap
02,0g Antenna
65,0g 4s 450mAh Battery


86,5g

Dirty Section
25,0g Frame parts
06,6g AIO
44,0g Emax 1306 Motors + Wire
08,2g Props (2,05g x 4)


83,8g

Discussion

Sign in to comment

Guides & Reviews

28 1,340  11
19 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
43 4,878  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more