My next Long Range Drone is finally finished. I built this a couple months back and had planned to put the new HDZero Freestyle VTX in once it came out, but I decided not to wait any longer and finish this drone using the Freestyle V1 VTX. I went with the GEP-LC75 V3 frame because it looked really cool with a lot of room inside. However I did find the V1 VTX barely fits inside the frame with the panels. The V2 will be a 20x20 VTX so if it fits better, I'll swap out the VTX. If not, I'll probably design wider backpanels. All the TPU is custom made is custom made. I went withe my normal arm guarde design, with padding on the top in order to reduce motor vabration and added landing skids. Because this uses dual diversity ExpressLRS antennas, I decided to redesign the front sidepanels and make them more useful by holding the antennas. The GPS mount is wider in order to hold the GEPRC GEP-M10-DQ GPS Module, which is bigger then the Matek M10Q-5883 I normally use. And I swapped out the FPV camera lens for the Caddx Polar Lens 1.6mm in order to get rid of the fisheye and get full 16:9 image at 1080p/30. All in all, I'm pretty happy with this build and can't wait to take it out for a spin.