My third build - original intention was to build the fastest and most durable 2" micro that I could. The Emax RS1106's are the obvious choice for motors, and for the frame, I opted to get the recently released Cerberus Micro. Compared to past frames micro that I've used, this frame is in another league in terms of strength and general build quality (top of mind are the super stiff 2.5 mm carbon with chamfered edges and clever design) at the cost of some additional weight (25 g vs 10 g for the Ascent V2 that I built). Unfortunately, the motors have let me down a bit with two of them having bad bearings which has put off my maiden by a week or so. Nonetheless, will report back with initial impressions.

On a side note, I have to acknowledge that this build is basically the same as Skittles by percisely, albeit his is cleaner :) (and honestly it was exactly the build I wanted)

Update - RIP, lost in service. Struck a ghost branch doing some high speed proximity flying which spun it into a big clump of branches where it remains. Will continue efforts to recover, but for now, it is presumed gone forever.