I have a problem where there is connection between the controller and the receiver, fc, and ESC (i know due to the "receiver" section on betaflight). Whilst the build is plugged into the computer and the battery, i can control the motors, but the controller does nothing whatsoever. Any help?
Make sure you set your channel order on the top right. It'll look like AETR or TEAR. There are some pre-determined options depending on what transmitter you're using.
I believe there's a preset for the Taranis in the channel map dropdown. I don't have a quad handy to plug in to double check, but just make sure the order is correct. I believe the QX7 should be TAER1234.
I fixed it to TAER1234 and it is correctly controlling it in the receiver tab, but now whenever i try to use the controller to spin up the motors, nothing happens. The controller has only effected the bars, but never the quad itself.
Did you configure the Modes tab? You need to assign Arm to a switch as well as your flight modes. I'd watch a few YouTube videos on configuring BetaFlight.
I have a problem where there is connection between the controller and the receiver, fc, and ESC (i know due to the "receiver" section on betaflight). Whilst the build is plugged into the computer and the battery, i can control the motors, but the controller does nothing whatsoever. Any help?
Have you bound your receiver? Can you control the bars on the Receiver tab?
Yes, but its incorrectly being controlled. Its taking the information as though it is a mode 1 controller, while i have a mode 2
Make sure you set your channel order on the top right. It'll look like AETR or TEAR. There are some pre-determined options depending on what transmitter you're using.
Im using the Taranis QX7, if that helps
I believe there's a preset for the Taranis in the channel map dropdown. I don't have a quad handy to plug in to double check, but just make sure the order is correct. I believe the QX7 should be TAER1234.
I fixed it to TAER1234 and it is correctly controlling it in the receiver tab, but now whenever i try to use the controller to spin up the motors, nothing happens. The controller has only effected the bars, but never the quad itself.
Did you configure the Modes tab? You need to assign Arm to a switch as well as your flight modes. I'd watch a few YouTube videos on configuring BetaFlight.
I got it running. Thanks for the help!