enrbgill commented on a Build, illiFPV:Chameleon Suki ed.   Jul 06, 2017  

What heat braid did you use to cover the wires? It looks a lot nicer than the stuff I've been using!

illifpv   Jul 06, 2017 

It is paracord 550 4mm thick. A little bit of a tight fit around the solder joints when extending motor wires. I'm using 20awg cable and thin heatshrink around those joints and some black heatshrink to hold it in place as you can se. Next time I will probably go for 5mm or 6mm. I bought about 16meters though so realistically I'm stuck with these for quite a while ;-)

enrbgill   Jul 06, 2017 

Paracord is a great shout, think I'll go 5mm and see! Gorgeous build too! Cheers

Are you sure you want to unfollow this person?
Are you sure you want to delete this?
Click "Unsubscribe" to stop receiving notices pertaining to this post.
Click "Subscribe" to resume notices pertaining to this post.