It's based off the darwinfpv babyape v2 frame, it's a lightweight 3 inch 3s quad.

This is just about as close as I could get to my dream build while keeping the budget reasonable.
It's also my first build and I learned a lot while building it.

The first modification the frame needed was to widen the motor holes to 2 mm and space them out 9 mm.

I mounted the vtx on the top plate since the holes there fit perfectly.
It didn't come with stack screws so I used my own, and I had to file down the front screw so the vtx could fit.

And the camera (caddx ant nano) had about 2 mm of room between the camera mount plates so I used a nylon nut as a spacer on one side.
That solved the issue but made the cam off center which really annoys me.

I used the jhemcu ghf411 40A aio board, I know that 40 amps is def an overkill but that never did anyone harm :)

The dry weight is 82 grams and all up is 120 grams.
Not as light as Kabaabs toothpicks but still pretty light.

All concluded I'm very happy with this build.