My first quad, built to learn basics and LOS flight.
I saw the frame on thingiverse few months back and always wanted to build it, so here it is.
I printed the frame from gray PLA first, but after going through 5 frames in 3 days, I printed it from yellow ABS, that frame is still going strong after many crashes.
The quad flies pretty nice with stock Betaflight 3.2.3 tune. First I wanted to add AIO camera to the quad and learn FPV, but I decided to build 5 inch mini rather than upgrade this little guy. It's fun flying it, but I got an itch for bigger one :P
Frame |
Micro 105 FPV Quadcopter - 8.5mm Motors, Micro Scisky by punkkills
Thingiverse.com
|
See Site |
Flight Controller |
Micro 32bits F3 Brushed Flight Control Board Based On SP RACING F3 EVO Brush For QX95 QX90 QX80
(3 builds)
Banggood.com
|
$10.99 |
Motors |
4 x 4X Racerstar 8520 8.5x20mm 53500RPM Coreless Motor Upgrade for Eachine QX80 DIY Micro FPV Quadcopter
(3 builds)
Banggood.com
|
$55.96 |
Propellers |
5X Eachine 3-Blade Propeller Prop 20Pcs for 7mm 8.5x20mm Coreless Motor DIY Micro FPV Quadcopter
(2 builds)
Banggood.com
|
$4.99 |
Receiver |
8/18CH Mini Receiver With PPM iBus SBUS Output for Flysky i6 i6x AFHDS 2A Transmitter
(30 builds)
Banggood.com
|
$6.48 |
Batteries |
5x Eachine 3.7v 500mah Lipo Battery with 4 In 1 X4 Battery Charger for H107L H107C H107D
Banggood.com
|
$16.98 |
AirbladeUAV has done it again and this time they've brought long range to the 5" class! Based on the popular Transformer Mini, the new Transformer 5" Ultralight adopts a lot of the same design philosophies with larger props and more payload capacity. It can fly upwards of 20 minutes on a 4 cell Li-Ion battery pack and in ideal conditions it's got a range of over 4 to 5 miles. In this guide I'll walk..
Read moreWith the release of the DJI FPV Drone cinematic FPV has become a lot more accessible, but you certainly don't want to crash a $750 drone! The QAV-CINE Freybott is a compact, lightweight cinematic FPV drone that can take a hit and keep going. It's a lot safer to fly indoors and around people. With a naked GoPro or the SMO 4k you can capture some great stabilized footage. In this guide I'll show you..
Read more
That's the spirit!!!! I hope I get to buy/fly a frame you design one day, I think you will go far in this hobby.
The frame is not my design, credits for that go to punkkils on thingiverse. But designing my own micro frame for 3d printing sounds like fun project for sure :P