Karearea TITI 3 ", HGLRC F440 Stack, TOA 1507-4200KV Motors & Foxeer Predator Micro V1.

Betaflight ver 3.5.1

The current antenna mounting is only temporary as i have ordered some antenna tubes but they wont be here for a while yet. I will be mounting them up along the back supports of the canopy when they arrive.

When using the HGLRC stack there is very little clearance between the outer motor solder pads and the canopy. barely enough to slide a thin piece of paper through, when i first assembled it i had continuity between the front right solder pad and the canopy. I had to remove some solder (i didn't use very much there to begin with) and adjust its position. unfortunately In a crash i imagine this will shift and cause continuity with the frame. Since i already had it soldered up i didnt bother turning it 90 degrees, remapping the motors and adjusting it in betaflight respectively. I'll just leave it as is until i know for definite if it will be an issue or not in time.