DLQ #8Bit brushed frame

By DLQFPV (pothman) on Apr 27, 2019

6  205  2

I designed this frame for @8bitchrist. Wanted a minimal brushed frame that would fit a 36x36 flight controller natively. I'm running 820 motors with betafpv lite board flashed with NFE fork of silverware.

Photos

Discussion

Sign in to comment

Squamous   Apr 27, 2019  
1

i may have to build one of these, love the rubberband support on the frame!

DLQFPV (pothman)   Apr 29, 2019 

Thanks. It's a fun frame I made for my friend. I had a small production of them made. Only 10 frames in the world right now. But if you want one they are at the link listed above.

Guides & Reviews

28 1,450  11
22 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
44 4,945  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more