Xinged Flynoceros Skoll V2 - 7" 5S

By Airmaxx23 on Jul 08, 2019

13  448  1

I've really been liking my 6" Skoll v2 frame (4mm arms) so I decided to build a 7" with 5mm arms. I designed the rear antenna mount and motor wire holders/guards and printed them along with the stock parts in purple to go with the Xing motors. I'm getting 10-11 minutes of flight time just cruising around with a 2200mAh 5S pack. I just got a couple different sets of props to try out, I'm hoping to extend my flight time a little.

Photos

Discussion

Sign in to comment

SpikeDiesel   Jul 14, 2019  

Nice bro, try the gemfan 7042 bis for those motors.

Guides & Reviews

24 1,826  27
20 days ago

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more
25 6,760  24
Nov 30, 2019

In late 2019 DJI made inroads into the FPV scene with their remarkable low-latency digital system. It gave us a 720p video feed with latency on-par with the status quo, analog video. Traditionally we've used analog video systems for low-latency video, but the video quality is far from ideal. It's a trade-off we've been willing to accept for the control. Now we've got the best of both worlds and what..

Read more