I got turned on to this frame flying with a friend and wanted to get one however no one had the frame so I contacted the EvolultionFPV directly. Mark @ EvolutionFPV informed me they no longer sold that frame however he would have one cut for me if I wanted so I jumped on the offer! It is not assembled as suggested as the rear motors are meant to be offset much more than they are the way I have put it together. So this is a learning and experimental experience and thus far it has been great, the frame is rock solid and I cannot thank Mark enough for having it cut for me.
One thing I do not care for especially with this build and using a 20x20 stack is the motor wires on these motors are way too big, in retrospect a different set of motors with a more traditional motor wire gauge would have been a much better choice so I may replace them with some RC 2207s. The pod is from a file I got on thingiverse.com and fit perfectly so I was thrilled with that however fitting everything inside was also a tough one but I put the XM+ under the stack and the Oscar Liang Backpack vtx is heat shrink wrapped and taped to the top of the fc with double sided tape. The antenna is jammed through a hole I made in the pod and is held friction fit quite nicely, I was concerned it would fly off but I have crashed this quad several times and it has held fast so again I am pretty happy.