Emax Tinyhawk Freestyle v1

By DetourFPV on Jul 05, 2020

7  219  0

This is a stock Emax Tinyhawk Freestyle v1 that I crashed, breaking the right front arm. I then enhanced the frame with an experimental material in order to add strength. We'll see how that works out. So far, so good. :)

I could not get the onboard RX to pair with my Taranis to begin with, so I added the FrSky RX.

I typically run it on a 2S 800mAh Tattu Lipo. I have already converted the battery plug to XT30.

Photos

Discussion

Sign in to comment

Guides & Reviews

29 1,573  11
26 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
44 5,035  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more