KISSed Alien 5" inch

By ogee on Feb 01, 2019

1  122  0

Just one more Alien 5" inch with KISS hardware.

Besides mentioned parts, all screws have been changed to Titanium

Part List

Frame

Alien FPV Frame (2 builds)
Impulserc.com
See Site

Flight Controller

KISS FC - 32bit Flight Controller V1.03
Shop.brickracing.com
$35.49

ESCs

4 x KISS ESC 2-5S 24A race edition - 32bit brushless motor ctrl (122 builds)
Flyduino.net
$88.00

Motors

2 x Cobra CP 2207 2450Kv Champion Series Motor
Shop.brickracing.com
$84.00

Propellers

HQ 5.1X3.6X3 Grey PC 2CW + 2CCW - POPO
Shop.brickracing.com
$3.20

Propellers

HQ 5X4.3X3 V1S Violeti PC 2CW + 2CCW
Shop.brickracing.com
$2.90

FPV Camera

RunCam Swift 600TVL 2.8mm PAL FPV kamera (2 builds)
Shop.brickracing.com
$28.00

FPV Transmitter

TBS Unify Pro 5G8 HV (SMA)
Shop.brickracing.com
$50.90

Antenna

TBS Triumph SMA (RHCP 2pcs) (2 builds)
Shop.brickracing.com
$39.90

Receiver

TBS Crossfire Nano RX
Shop.brickracing.com
$31.90

Batteries

MyLipo 1300mAh 4s 14,8V 50C/100C FPV Parcour Lipo Pack (5 builds)
Shop.brickracing.com
$26.60

Batteries

Leopard Power 1300mah 95C 4S
Shop.brickracing.com
$25.50

Power Distribution

Mr Steele Alien PDB + Microphone + KISS OSD (3 builds)
Team-blacksheep.com
$45.00

Goggles

Fatshark Dominator HD3 Core FPV Goggles (2 builds)
Shop.brickracing.com
$425.00

Video Receiver

Furious True-D V3.5 Diversity Receiver System Firmware 3.7
Shop.brickracing.com
$80.00

Radio Module

TBS Crossfire TX Lite (2 builds)
Shop.brickracing.com
$156.40
Show stores (4)

Discussion

Sign in to comment

Guides & Reviews

22 1,078  11
14 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
42 4,740  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more