NanoShark Proto

By jdmkramer on May 18, 2018

7  239  0

Thanks to Fissionbomb and LAZD for the surprise parts!

Flies great with some random 8520 whoop props I had laying around, and 600 1s that hasn't seen action since I got a tinyshark. Finally a use for all my old brushy bits!

Photos

Part List

Flight Controller

Banggood.com (8 builds)
Banggood.com
See Site

ESCs

4 x (3 builds)
Banggood.com
See Site

Motors

Sunnysky 0703 15000KV Brushless Motor – 4pcs (2 builds)
Flexrc.com
$40.00

Propellers

BetaFPV 48mm 3-blade Micro Whoop Propellers
Kadosmultirotors.com
$2.99

FPV Camera

AKK AIO-SA Whoop/Micro AIO FPV Camera & 25-200mW VTX w/ Smart Audio (7 builds)
Racedayquads.com
$24.99

Receiver

uSKY Frsky Nano Receiver (3 builds)
Readytoflyquads.com
$6.99

Batteries

Tattu 25C 1S 3.7 v 600mah Lipo Battery Pack with Molex Plug ( 6pcs) (2 builds)
Genstattu.com
$17.59

Radio

Jumper T16 Hall BLOWOUT (2 builds)
Team-blacksheep.com
$139.95

Goggles

Fat Shark Dominator HDO2 OLED FPV Goggles (21 builds)
Racedayquads.com
$499.00

Radio Module

TBS Crossfire TX LITE - Long Range R/C Transmitter (29 builds)
Team-blacksheep.com
$149.95

Soldering Iron

TS100 Portable Programmable Smart Soldering Iron (171 builds)
Racedayquads.com
$51.29

Tools

Mini All-In-One Hex Driver Tool
Racedayquads.com
$13.99

Accessories

TBS Diamond Antenna (27 builds)
Getfpv.com
$24.95
Show stores (8)

Discussion

Sign in to comment

Guides & Reviews

28 1,316  11
19 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
43 4,857  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more