Mockup

ImpulseRC Reverb 5" with Wolf PDB

By lblb on Jul 14, 2018

0  155  0

Part List

Frame

REVERB 5" Frame
Pirofliprc.com
$81.41

Flight Controller

KISS FC V2 - 32bit Flight Controller (55 builds)
Flyduino.net
$55.95

ESCs

4 x KISS ESC 2-6S 32A (45A limit) - 32bit brushless Motor Ctrl (17 builds)
Flyduino.net
$115.68

Motors

4 x Lumenier RX2206-11 2350Kv Motor (38 builds)
Getfpv.com
$75.96

Propellers

HQProp DP 5x4.3x3 PC V1S Black Propeller - 3 Blade (2CW+2CCW/Bag) (376 builds)
Getfpv.com
$3.60

FPV Camera

RunCam Eagle 2 FPV Camera - 16:9 (98 builds)
Getfpv.com
$44.99

FPV Transmitter

TBS UNIFY PRO 5G8 HV (RP-SMA) (82 builds)
Team-blacksheep.com
$49.95

Antenna

TBS TRIUMPH (2PCS) RP-SMA Version (58 builds)
Pirofliprc.com
$29.95

Receiver

FrSky X4R-SB - 3/16 Channel Receiver with SBUS and CPPM without pins (128 builds)
Getfpv.com
$22.49

Batteries

SLS NOC Race 1300mAh 4S1P 14,8V 2N
Stefansliposhop.de
$26.75

Power Distribution

ImpulseRC Reverb PDB OSD (Codelayer Wolf)
Store.rotorriot.com
$49.99

HD Camera

GoPro Karma Grip for HERO5 Black
Getfpv.com
$299.99

HD Camera

LayerLens for GoPro 3 & 4
Getfpv.com
$24.99

HD Camera

GoPro HERO5 Session (267 builds)
Getfpv.com
$199.99

HD Camera

GoPro Session (59 builds)
Getfpv.com
$149.99

Misc Parts

2 x ImpulseRC LiPo Strap - Small (3 builds)
Impulserc.com
$5.40

Misc Parts

3M Scotch 5952 VHB Tape: 1 in. x 15 ft. (Black)
Amazon.com
$15.99
Show stores (8)

Discussion

Sign in to comment

Guides & Reviews

26 1,241  11
17 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
42 4,827  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more