Realacc x210 Spec Racer

By moteasa on Nov 17, 2016

3  448  7

With exception of the VTX, this is about the cheapest I could get a great performance quad. Right at $200 with the optional LED/buzzer and some motor protectors. We have started a "spec racing" class based on the package deal from Banggood using this or the non-clone frame, The 20A RacerStar ESC, The 2205 2300kv RacerStar motors, King Kong 5040 tri props, and your choice of any F1 or F3 flight controller. FPV system and radio is pilots choice. We've been very happy with the performance so far. Check the link for some footage and build tips.



Sign in to comment

taurus   Nov 18, 2016  

I've been looking for a 3D printed camera protection just like the one you have. Is it your own design? Would you be willing to share it? I'd be much obliged ;)

Show 1 more comment
moteasa   Nov 21, 2016 

It is 3D printed. This is in ABS and a first revision. Another guy is doing the design for me so we have some tweaks to make for it to fit better. It does look great though and he did a good job. After this next revision I'll see how it is and if he's willing to share on thingiverse.

taurus   Nov 21, 2016 

Thanks a lot, keep us informed if you can!

taurus   Dec 18, 2016 

Is there any new development by any chance? Thanks!

Whiffles   Nov 17, 2016  

What sort of batteries are you running on these?

moteasa   Nov 17, 2016 

1300mah 4s of any flavor really. The 2300kv motor and 5040 tri prop combo isn't extremely taxing.

Guides & Reviews

28 1,450  11
22 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
44 4,945  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more