Whoopster One Ten

By quad66 on Jul 04, 2019

7  741  0

Finally got the 1s F3 Crazybee board flying well. The frame is designed with enough spacing under the board to be able to keep the board "right side up" if you want to do a direct transplant from a whoop. Also, the mount now has a little more motor protection and is "universal-ish" accepting the Happymodel 3 hole motors and the 4 hole 1103 motors. See the videos. And yeah, this much fun shouldn't be possible on 1S.

Dry weight 25.5 gm
AUW 33 gm

Photos

Discussion

Sign in to comment

Guides & Reviews

28 1,471  11
22 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
44 4,962  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more