Extreeeeeem SlamNasty

By JimmyProton on Aug 22, 2019

29  1,422  7

Is your "Super Slam Nasty" falling short of your slammed hopes/desires/dreams? When you walk out to the line and place your quad on the launch pad do girls look your way, point and giggle at the height of your stack? (or are you just imagining it)? Or do you just want MORE SLAM?!?! Then here's the build for you... The "SlamNasty Extreeeeeeeem" edition. Yes it has not 1, but 2mm more slamocity than even the "Super" slam can muster. THAT's ALMOST 80 thousands of one inch! Dooooooo iiiiiittttttt!!!!!!!

Photos

Discussion

Sign in to comment

noxnow   Jan 11, 2020  

Is the STL available for the 3D printed cam mount?

JimmyProton   Jan 12, 2020 

No. but it could be. Ill throw it up on Thingiverse tomorrow and post the link here. Cheers!

Quantum FPV   Aug 24, 2019  

Did you 3D print that cam protector thing in resin?

JimmyProton   Aug 25, 2019 

Yup. FormLabs - Durable Resin.

Quantum FPV   Oct 18, 2019 

Sick! Do you own one?

JimmyProton   Dec 02, 2019 

Yes. This was the Form 2 but I just upgraded to the Form 3. Its reeeealllly nice.

Guides & Reviews

26 1,241  11
17 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
42 4,827  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more