Japalura 3' - Red Mamba

By ae_fpv on Sep 14, 2019

3  265  0

Previously, I had used a 30 x30 stack in the Japalura Frame. However, I found the Diatone Mamba 20 x20 stack at a reasonable price. The stack does allow for more room to place and protect the electronics. Due to the small size of the stack, the soldering is tedious, but not too difficult to install. Make sure you recognize that the ESC plug for the flight controller has 2 extra pins for the buzzer. Therefore, follow the instructions for proper placement of the connector.

Photos

Discussion

Sign in to comment

Guides & Reviews

27 1,316  11
19 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
43 4,857  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more