Boldclash B03 Pro Upgraded Whoop

By OptimaZe on Jan 07, 2020

11  107  0

Just a simple B03 Pro that I upgraded with a 3D printed cam/VTX mount, and installed a Turbowing Cyclops2 AIO system onto. The camera mount is printed in Gizmo Dorks black light reactive filament, and housed in a clear BetaFPV canopy.

Photos

Discussion

Sign in to comment

Guides & Reviews

29 1,579  11
26 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
45 5,038  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more