StickiX 3" CFK Pod

By FPVFrame.ch on Jan 10, 2020

13  273  0

The StickiX 3" is one of my favourite racers at the moment! simply brutal on 4S The CFK Pod protects perfectly, no more damaged cam/vtx!

3mm bottomplate, chamferred edges
quick swap Lipo mount
countersunk fc screws for Lipo protection
116mm diagonal

As always, inputs and ideas are welcome!

Photos

Part List

Frame

StickiX
Fpvframe.ch
$24.90

Flight Controller

PYRODRONE AIO-412T (FC+ESC AIO) (4 builds)
Pyrodrone.com
$42.99

Motors

4 x GR1204 Motors - GEPRC (2 builds)
Geprc.com
$47.60

Propellers

Gemfan TRI-BLADE 3016x3 Props (4CW + 4CCW) - 2MM hub hole (14 builds)
Fpvcycle.com
$5.19

FPV Camera

RunCam Racer Nano 2 (2 builds)
Shop.runcam.com
$35.99

FPV Transmitter

TBS UNIFY PRO32 NANO 5G8 (222 builds)
Pyrodrone.com
$29.95

Receiver

TBS Crossfire Nano RX - FPV Long Range Drone Receiver (696 builds)
Team-blacksheep.com
$24.95

Batteries

Gaoneng GNB 15.2V 450mAh 80C 4S HV 4.35V Lipo Battery XT30 Plug for FPV Racing Drone (5 builds)
Banggood.com
$14.99
Show stores (7)

Discussion

Sign in to comment

Guides & Reviews

22 1,077  11
14 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
42 4,739  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more