Eyebreaker 65mm 1S Toothpick

By OptimaZe on Mar 11, 2020

15  214  0

3D printed 1s build. Not a speed demon, but super fun to fly none the less. Comes in at 46g all up with GNB 450mah LiHV batts.

EDIT-3/28/2020 Finally got some Gemfan 65mm props to try on this build :)



Sign in to comment

Guides & Reviews

28 1,340  11
19 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
43 4,878  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more