Apus 3" Toothpick - Build 3

By rodrigo_sclosa on Apr 13, 2020

10  236  0

This is one build i've done of my 3" SQRT Toothpick. You can find the full project at: https://rotorbuilds.com/build/22651
The BF 4.1.1 dump can be downloaded here: https://drive.google.com/open?id=1j6UyBds_jqRIJ663zFi4yJodnMe4bcl8

If you liked this, please consider to buy me a coffee at https://www.buymeacoffee.com/rodrigosclosa

Join my FB Group to get support: https://www.facebook.com/groups/1008586842873746/

Photos

Discussion

Sign in to comment

Guides & Reviews

27 1,301  11
18 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
43 4,847  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more