Marmotte 5" dji

By Waffles on Jun 23, 2020

13 3 3

transfer from chameleon, tmotor f55, xings 2306, tbs and some axiis.

Photos

Part List

Frame	Marmotte DJI Edition (12 builds) Armattanquads.com	$114.00
Flight Controller	Holybro Kakute F7 HDV 30x30 Flight Controller for DJI (28 builds) Racedayquads.com	$37.99
ESCs	T-Motor F55A Pro II 32Bit 55A 3-6S 30x30 4in1 ESC (62 builds) Racedayquads.com	$93.89
Propellers	HQ Prop ETHIX S4 5x3.7x3 Tri-Blade 5" Prop 4 pack - Lemon Lime (60 builds) Racedayquads.com	$3.49
FPV Transmitter	DJI Digital FPV Air Unit - Ultra Low Latency 720p 120FPS Digital HD Racedayquads.com	$179.00
Receiver	TBS Crossfire Nano Rx - FPV LONG RANGE DRONE RECEIVER (1506 builds) Team-blacksheep.com	$24.95
Batteries	Ovonic 1000mAh 6S 100C LiPo Battery with XT60 Plug for FPV Racing RC Quadcopter Helicopter Airplane Multi-Motor Hobby DIY (31 builds) Amazon.com	$21.99

Show stores (4)

Like Copy Part List Follow Waffles

Discussion

DG FPV Jul 24, 2020

Did you use the connector or did you solder the DJI cable to the FC?

Waffles Jul 25, 2020

I just used the connector, I cant remember if the cables had to be rearranged though..

tylerrgale Jun 29, 2020

This is definitely a noob question, but why do you have the 4 in 1 HolyBro ESC and the T-Motor individual ESCs together?

Waffles Jun 29, 2020

My bad, I didn't realize the FC in the drop down included the holybro ESC. Thanks for pointing that out, I'm only using the HDV FC paired with the Tmotor ESC.

tylerrgale Jun 27, 2020

Are you running an extra capacitator to support the 6s battery?

Waffles Jun 27, 2020

yea theres a cap, 35v, cant see how many uf but prolly 400 or 600 ish. I used thick double sided tape and just zip tied it to the frame. I cut the metal leads short on the cap and solder 20gauge wire to it and then run the wires to the battery pads of the esc. hope the pictures help.