Spare Parts build! GNarlyFPV 65mm old style Primo.

I have run everthing from 1s 5amp 1103 18000kv then 1s and 2s 6amp 1103 8000kv all with good results. The best and last setup was a 2s only betafpv 12amp 1103 8000kv all with Caddx Ant Echine Nano 400mw VTX and Tiny D8 RX installed due to space issues. The Tiny D8 was my downfall as I normally run crsf and had flown two of my other micros "crsf" before flying this one at the lake. I ended up getting an RX loss and flowting down into the lake. Here is it's last flight -=>

Note - I have a GnarlyFPV Primo 3 inch on the way with Motors and Two new AIO's to try out.

1/23/2020 Update

Well I hate what GarlyFPV has done with their new frames! Hate is not a strong enough work actully. I tracked down one of these however and plan on doing a new build with parts targeted spicificly for this model. Its going to be a little BAMF!