Tiny Hawk with Talons

By Mountainlovingsurfer on Jan 15, 2021

13 114 3

Tiny Hawk Frame running a Vista with a Tiny Talon F7 flight controller .
A custom carbon part fitted at the back to mount the Vista Antenna plus the XT30 / Capacitor .

Photos

Part List

Frame	EMAX Tinyhawk II Freestyle – Replacement Bottom Frame Plate Unmannedtechshop.co.uk	$6.63
Flight Controller	16X16mm Tiny TALON F7 2S~4S 17V Flight Controller FPV Stack With BLHeli_32 20A ESC for RC FPV Racing Drone (3 builds) Au.banggood.com	$59.99
Motors	4 x iFlight XING NANO X1105 1105 4500KV 6000KV 2-4S CW Thread Brushless Motor for iH2 iH3 120RS FPV Racing Drone (3 builds) Banggood.com	$66.12
Propellers	AVAN Rush 2.5 Inch PropDefault Title (13 builds) Pyrodrone.com	$1.59
FPV Camera	Caddx Nebula V2 Nano Digital HD VTX Air Unit Kit for DJI (47 builds) Pyrodrone.com	$134.99
Misc Parts	3Pcs CJMCU 1 Bit WS2812 5050 RGB LED Driver Development Board (2 builds) Uk.banggood.com	$2.75

Show stores (5)

Like Copy Part List Follow Mountainlovingsurfer

Discussion

BaTTaN Jan 31, 2021

Nice THFS! I was running a mamba 12a AIO with NBD Flow 1202 motors. Ended up going through two bottom plates before moving to Microheli's THFS frame. Theirs is much better as it allows you to mount darn near anything in it.

Melvis Jan 28, 2021

Wow, well done. You don't see too many if any 2 1/2 inch builds, let alone on a Tinyhawk 2 FS.

Loser32p Jan 16, 2021

where did you find the adapters to mount the 16x16 stack? Id like to make an analog version.

Mountainlovingsurfer Jan 16, 2021

Hello 32p , when you say adapters for the stack I didnt use any , I just used the frame of the Tiny Hawk with extra holes just a few mm in front of the rear standoff post holes which are also 16 mm apart .
then placed bolts just in the corner of that section of frame and in said holes 👍