Had some components that needed put to good use so decided to print out the NFE Boss 8 frame. It's running on a Boldclash B03 Pro FC flashed with NFE Silverware firmware. 8520 motors are spinning Gemfan 65mm props. Camera is mounted in a 3D printed micro pod designed by Dave C FPV. This thing is incredibly quiet in the air, and a lot of fun to fly.
Photos
Part List
Flight Controller |
BoldClash BWhoop B03/B03pro Receiver Board
(7 builds)
Boldclash.com
|
$5.99 |
Motors |
Makerfire 4pcs 8.5x20mm 15000KV Brushed Motors 1.0mm Shaft with Micro JST 1.25 2P Connector CW CCW 8520 Coreless Motors for Tiny
(8 builds)
Amazon.com
|
$15.99 |
Propellers |
Gemfan 65mm Micro Propellers (1mm Shaft - Set of 8)
(14 builds)
Getfpv.com
|
$2.99 |
FPV Camera |
AKK BS2 5.8G 40CH 25mW VTX 600TVL 1/3 Cmos AIO FPV Camera for FPV Drone Like Tiny Whoop Blade Inductrix etc
(19 builds)
Amazon.com
|
$1.00 |
Batteries |
GAONENG 6PCS 1S LiPo Battery 30C 3.8V LiHV Batteries for US65 UK65 URUAV UR65 Mobula7 Tiny Whoop Micro FPV Racing Drone with JST
(9 builds)
Amazon.com
|
$1.00 |
3D Printed |
Toothpick Nano Pod Lite [14mm] by Dave_C_FPV
(13 builds)
Thingiverse.com
|
See Site |
Where did you find the file for the frame?
I had the files saved from the micro motor community. Unfortunately it looks as though that forum is now a thing of the past :( I have the stl files for the Boss 8 for Whoop boards, and E010 B03 etc style boards saved. I'd be happy to send them to you if you want.
Please! Would you post them to thingiverse?
I'll put them up on Thingiverse asap. I'll let you know once I get them on there.
Forum is back up and running. Files for all of the Boss series frames can be had in this thread https://community.micro-motor-warehouse.com/t/notfastenuf-boss-series-brushed-frames-3d-printable-v2-stl-files-post-368/5076