ok so here is my first attempt at a full build. I've replaced/upgraded stuff on other quads I own enough so I figured it was time to go for it. most of the things in the build I'm familiar with other than the flight controller. it actually was super easy to solder to and the wire diagram is pretty straightforward but the board itself is also labeled so it was a breeze to attach everything (my solder isn't the best I know but still learning). the hardest part about the build was trying to figure out where to put the lost drone led buzzer. I do the occasional night runs so I wanted the leds plus they look kinda sweet lit up, I also added reflective yellow tape to the front and rear of the frame to help plus it helped dress it up a bit. haven't gotten a maiden flight yet just a garage hoover last night after it was done hoping the weather clears up and I can get at and report back with some footage.