Not my first build but my first post!

I decided I wanted to build an Armattan Gecko 6S ripper. Nothing about this build was going to be on the budget side so first up was finding some motors. I will admit i was looking for something flashy and different than the typical 14XX,15XX style motors that everyone uses and I stumbled upon these FPVCycle 21mm 1620kv. The white got me and then I seen they were 6S capable. I ended up getting the lower 1620kv instead of the higher 2300kv version because well 6S you know. Not sure if they're any less powerful but this thing sure does move anyway. Then was finding a stack. Settled on a Tmotor Mini v2. The ONLY problem i had with fitment was with this particular stack the ESC has a bigger foot print and power pads that protrude out the rear. On the Gecko frame the space between rear standoffs is very tight so I had to grind them down and make sure there was enough clearance between the pads so nothing would short out. I also conformal coated the lipo pads for extra protection.

Honestly I love this quad and the way it flys. Small and nimble and has the power to boot. Ended up weighing 223g without a lipo and roughly 400g with one and a Insta360 GO Camera.