OOOmeleon

By Bonnervision on May 27, 2017

3  316  0

Orange Armattan Chameleon

RaceDayQuads.com gives 5% of purchases back to your local MultiGP chapter. Have your organizer contact Tyler to signup and get your chapter a code.

The Emax 2306 motor wires are a little short for 4:1 esc use on this size frame
Wires too short

So I extended them
Extended Wires

Here it is fully built with the super hyped Thrust UAV battery Strap
Built w/ session

Photos

Part List

Frame

Chameleon (154 builds)
Armattanquads.com
$90.00

Flight Controller

Raceflight Revolt V3 Flight Controller - Latest Version (70 builds)
Racedayquads.com
$38.88

ESCs

RaceFlight Bolt V2 4n1 ESC - 30a DShot 600 (38 builds)
Racedayquads.com
$64.99

Motors

4 x EMAX RS2306 White Edition 2400kv FPV Racing Motor (86 builds)
Racedayquads.com
$79.96

Propellers

RaceKraft 5" 5040 Tri-Blade Race Props - Clear, Blue Clear, Gold, Smoke (44 builds)
Racedayquads.com
$2.99

FPV Camera

Foxeer Arrow V3 2.5mm Lens FPV Camera with Built-in OSD - Blue, Silver, Black, Orange (131 builds)
Racedayquads.com
$29.99

FPV Transmitter

TBS Unify Pro 5G8 HV (SMA) (586 builds)
Getfpv.com
$49.99

Antenna

TBS Triumph Antenna SMA RHCP (Set of 2) (543 builds)
Racedayquads.com
$37.99

Receiver

FrSky XM+ SBUS 2.4GHz Mini ReceiverDefault Title (1423 builds)
Racedayquads.com
$12.99

Batteries

Amazon.com (28 builds)
Amazon.com
See Site

HD Camera

GoPro HERO5 Session (267 builds)
Getfpv.com
$199.99

Misc Parts

2 x KODAK RIOT
Thrust-uav.com
$9.98
Show stores (5)

Discussion

Sign in to comment

Guides & Reviews

29 1,576  11
26 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
44 5,037  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more