Neato Pipsqueak 3"

By flying toaster on Jan 14, 2018

2 12 2

Photos

Part List

Frame	Neato Pipsqueak 3 Inch (5 builds) Neatoframes.com	$49.00
Flight Controller	OMNIBUS F4 Nano v3 with LC filter (4 builds) Store.myairbot.com	$35.99
ESCs	Ori32 4in1 ESC 4x25A 2020 (83 builds) Store.myairbot.com	$44.99
Motors	4 x RotorX 1404 3600kv Brushless Motors – MultiRotorMania (2 builds) Multirotormania.com	$63.96
Propellers	RotorX RX3044TX 3" X-Mount High Performance Tri-Blade Propellers – MultiRotorMania Multirotormania.com	$3.99
FPV Camera	Foxeer Predator Micro Camera FPV OSD 1000TVL Super WDR Surveilzone.com	$36.90
FPV Transmitter	Eachine VTX03 Super Mini 5.8G 72CH 0/25mW/50mw/200mW Switchable FPV Transmitter (417 builds) Banggood.com	$12.22
Antenna	Lumenier AXII U.FL 5.8GHz Antenna (RHCP) (148 builds) Getfpv.com	$14.99
Receiver	FrSky R-XSR Ultra Mini Redundancy Receiver (937 builds) Horusrc.com	$19.89
Batteries	PULSE 450mAh 4S 14.8V 75C - FPV Racing series - LiPo Battery (5 builds) Helidirect.com	$13.99
Misc Parts	TrueBlood - Dampening Standoff 2.3mm Soft (2 builds) Readymaderc.com	$4.99
Misc Parts	Amass XT30U 2mm Plug Connector Male And Female 1 Pair Banggood.com	$1.99
Misc Parts	Panasonic Electronic Components (3 builds) Digikey.com	$0.64

Show stores (10)

Like Copy Part List Follow flying toaster

Discussion

SystemRotor Jan 15, 2018

Mate very clean solder work what solder are you using and your solder iron temp .

flying toaster Jan 15, 2018

Thanks! I'm using 63/37 rosin core. For those pads I was at 350C. I use as thick of a tip on the iron as I can and also put a small dab of flux paste on the tinned pads. Solder: https://www.amazon.com/gp/product/B005T8NEFG/ paste: https://www.amazon.com/MG-Chemicals-Clean-Paste-Syringe/dp/B00425FUW2/

SystemRotor Jan 15, 2018

Thank you for that information .

SystemRotor Jan 15, 2018

Mate what flying time do you have .

flying toaster Jan 15, 2018

I had an issue with the camera so I haven't gotten any proper test flying in yet but these motors have a low amp draw. I believe I'm getting a little over 3 min with a 4S 450mah pack. I can report back once I have a better idea.