Red Taycan

By M490fpv on Feb 02, 2020

13  704  6

This is my second Taycan build.
I like the frame quality very much and wanted to build another taycan with different color scheme.
I chose the Emax RS 1606 3300kv motors, so this bird is limited to 5S.
Printed the ducts and cam plates of transparent red PETG and all other red parts of Sainsmart red TPU. Dji air unit mount is printed of Extrudr black TPU 98A.
Painted the cam cage parts black to match the colors.
Still need to trim some props to it, these gemfan squirt props are a bit short.

All printable parts: https://www.thingiverse.com/thing:4081921

Photos

Part List

Frame

DIATONE MXC Taycan Cinewhoop Duct 3" Frame Kit
Drone-fpv-racer.com
$117.77

Flight Controller

Aikon F7 Mini HD V2 Flight Controller
Drone-fpv-racer.com
$48.22

ESCs

Aikon AK32PIN 4in1 35A 6S (4 builds)
Drone-fpv-racer.com
$70.62

Motors

4 x Moteur Brushless Emax RS1606 - 3300Kv (3 builds)
Drone-fpv-racer.com
$68.36

Propellers

GEMFAN Squirt Props 75mm (6 builds)
Drone-fpv-racer.com
$3.17

FPV Transmitter

Unité aérienne DJI FPV (131 builds)
Drone-fpv-racer.com
$222.81

Receiver

TBS Crossfire Nano RX (SE) (336 builds)
Drone-fpv-racer.com
$39.96
Show stores (1)

Discussion

Sign in to comment

sedwo   Jun 06, 2020  

What are those MMCX to SMA connectors you're using to attach the DJI AIr Unit to the antenna's?

Guides & Reviews

27 1,309  11
18 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
43 4,856  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more