7mm Beecore v2

By FissionBomb on Jan 08, 2018

17  533  0

12/31/17 - Building a 7mm whoop piece by piece now that I've seen how BetaFPV built their Flysky BNF. They VHB'ed an RX to the base of their FC.

01/05/18 - Put everything together and realized I got the wrong size props. I need 31mm with a 0.8mm shaft hole. 40 are too large for the ducts and have a 1mm shaft hole. The BetaFPV board is not powering up and I'm negotiating a remedy with their Service team. I've purchased a Beecore V2 with OSD and onboard Ibus Flysky Receiver in the meantime. RacedayQuads.com had a 10% off sale.

01/08/18 - Beecore arrived today and I had it bound and soldered within minutes. To use Ibus with the Flysky version you must select Uart3 and have Serial Based selected in the configurator tab of Betaflight. This board will use AFHDS 2A unlike the original. Maiden hover went well. I can't wait to finish the break in period and really rip this thing around. It sounds so mean in the air. Running 4 blade props from my Eachine E010 which happen to perfectly match the canopy.

Photos

Discussion

Sign in to comment

Guides & Reviews

28 2,469  33
28 days ago

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more
26 6,964  24
Nov 30, 2019

In late 2019 DJI made inroads into the FPV scene with their remarkable low-latency digital system. It gave us a 720p video feed with latency on-par with the status quo, analog video. Traditionally we've used analog video systems for low-latency video, but the video quality is far from ideal. It's a trade-off we've been willing to accept for the control. Now we've got the best of both worlds and what..

Read more