Once I get back on that thing, I'll find out what they are and post back here!

sweet! thx!

Good eye! As you can see in the "build" pictures, I had that same antenna. Very short, I even had to remove the heat shrink to get it through that hole. I had an extra VTX03 dipole antenna laying around (because I swap them with SMA Pigtails) and the length on that antenna was just long enough. You won't toast the cam with any wrong antenna at least, just make sure there is an antenna! Good luck on your build!

Thanks Cleaner. i lengthened the whip with some 22awg wire....not sure if that will work and have already ordered a longer whip in anticipation of failure. (!) FYI you can clean up the hole in the canopy with a 3/16" drill bit, just twist it by hand and the the whip slides through. cheers

Mike, how did the extention of the antenna go?

hahaha Flatline! i ended up buying a replacement i did not use a small coaxial type wire and it did not work! lesson learned

It should work just fine on 1s, though may feel a bit sluggish. Maybe have more of a whoop feel.

Thanks for your response. Just trying to decide if I need a 2s tiny shark or not.. you make it look awesome!

You definitely need one! If you want something extremely small and light, I'd definitely build this again. I also have a 2in. eclair that I am using 4S on. That thing is a monster! This one feels much more tame.

I'm not sure yet actually! I've been waiting for a good day to fly it. Also, I have old batteries, so I'm not sure if they're going to be as long lasting as I'd like. But it should clear up in a few days here and I can report back.

I prefer sasquach. hahaha! Also, that thing is TINY

43g dry, 77g auw with a 2s 450mah battery. Not the lightest, but i wasnt concerned too much with weight on these motors and 2s