WhoppyF1SH

By q-ratz on Mar 09, 2018

7  389  0

I loved my pepperf1sh. But indoors I was breaking a lot of props and leaving many marks on walls and furniture. And for outdoors i by far prefer my pepperfiish on the tinyshark frame. So I transferred the electronics from the pepperf1sh to the betafpv whoop-style frame. I designed a TPU adapter plate to mount 16x16mm hardware to the betafpv frame. Finally, I adjusted flexrc's 16x16mm cam mount to my needs. It is running betaflight with the settings from project mockingbird which makes this thing real fun indoors. The motors are the new style 0703 from boldclash (sealed bottom) at 15000kv. I fly for about 2 minutes before the 260mah 1s lipos come down pretty hot :). Maybe I'll try the 550mah 1s lipos once they are available anywhere. It weighs 25gr without lipo.
Check for the TPU parts here: https://www.thingiverse.com/thing:2809628

Photos

Discussion

Sign in to comment

Guides & Reviews

28 1,450  11
22 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
44 4,945  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more