Rotorious FPV Cb3 - 2.5" 3s (Screamer)

By theres_just_no_tellingFPV on May 14, 2018

9  556  3

Note: This build is using the unreleased Rotorious FPV Cb3 w/ replaceable arms and the 3b-r 1105 7500kv.
Firmware: Butterflight 3.5 (8k8k, Q=1200, R=88)

2s Flight Footage.

3s Maiden w/ minimal tuning.

Fully tuned 3s flight comming soon.

Photos

Discussion

Sign in to comment

Arnaud   Aug 01, 2018  

Nice little monster, but 7500kv 1105 is that not to much KV on a 3s lipo ?

theres_just_no_tellingFPV   Aug 01, 2018 

Hey ARNAUD, it is pretty high but worked out totally fine. Flight times where a little short about 3 minutes, crazy punch tho. Since then i have upgraded my motors to hawksky 1107 5500kv to run 3" props, now i have almost the same punch but my flight times are about 4 minutes and the control is much better.

Arnaud   Aug 02, 2018 

Nice !! For my ET125 I think i will take the 1105 6000kv on 3s with 2540 Gamfan or 2840 Kingkong props, For me 1107 is to high as i have prop guards :/

Guides & Reviews

22 1,622  13
8 days ago

The iFlight XL5 V3 is a fantastic freestyle frame for the price. It features chamfered edges on some very nice quality carbon fiber. My goal for this build was to use high quality components at a relatively low price. Not only that, but I managed to reduce the number of solder points to the bare minimum. I've never built such a plug-in-play quad! The flight controller has an integrated VTX and doesn't..

Read more
12 2,319 
Nov 16, 2018

Update! Happymodel has released a new V2 Frame which uses a more durable plastic. The Happymodel Mobula7 is one of those rare treats to hit the micro scene. Countless models hit the market every month, but this one just happens to check all the boxes. It's a 2S brushless micro with a 75mm motor stance. It's slightly larger than the more traditional 65mm brushed micros, but it's still quite small...

Read more