That experiment

By The giant bee on Jul 08, 2020

7  205  5

This is an old build running a kk2 board and simonk escs
I have decided to put an omnibus f4, run INAV for some GPS stuff and added a servo at the bottom cuz y knot : D


  1. these motors are not the ones I'm using. Use the ones you prefer (who knows, maybe even a 2510!!)
  2. the FPV system is one that i had laying arround I added a camera that IMO works well and is cheap and the video transmitter is the one I'm using (just don't... use a better one)

IDK how is it going to fly •_•

I'll keep you updated

08/07/2020: I finished setting it up, it arms and ... the servo works (wooo) I'm test flying it someday.



Sign in to comment

P1apex   28 days ago  

best drone for capture real time imaging.

The giant bee   27 days ago 

I couldn't agree more if the thing actually worked but it won't respond to stick commands (only throttle). The drone is an anarchist and goes wherever it wants to go :/

Rudygon   Jul 10, 2020  

my first build back in 2013 looked just like this. kk2 and simonK flash:)
if you are serious about flying this get current esc's. and maybe motors:)

Rudygon   Jul 10, 2020 

or just put that kk2 back i there lol

The giant bee   Jul 10, 2020 

I can put oneshot 125 escs for now l_•-•_l

Guides & Reviews

29 1,573  11
26 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
44 5,035  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more