P180 is a custom designed high-performance yet durable 5" FPV racing quadcopter.

It was designed in CAD software as a complete vehicle not just the frame, optimized around the components that it uses.

It's milled from a 4.4mm quality carbon sheet as the main frame and three additional 1.7mm carbon plates protecting the internals, making it hard to break.

Features:

• X-shape minimum size frame to fit 5 inch props (actual motor-to-motor diameter is 183.85mm).
• Milled from a quality 4.4mm carbon fiber sheet, making it nearly indestructible.
• The main components are housed between 3 sheets of carbon for protection.
• The VTX is placed in a milled pocket of the frame, held in by double-sided thermal tape, effectively making the entire frame a heatsink for it.
• There's a small lightpipe providing visibility of the two red and blue VTX status LEDs.
• Includes a PDB with OSD.
• There's a built-in loud buzzer.
• XT60 battery connector is firmly sandwiched between the carbon sheets and 3D-printed plastic, making it survive hard crashes.
• There's a 4S battery balance plug holder so it won't find its way into the props.
• There's a slot for the battery strap, just small enough to keep it in place.
• The camera angle can be easily changed from 0 to 40 degrees.
• There are small holes to access all of the buttons (RX bind, VTX setup, FC boot button).
• The antenna is firmly held in place by two small and one large cable tie.
• The motors are protected by another layer of the 4.4mm carbon, held in by three M2 screws each.
• The carbon sheets have chamfers milled in for countersunk screws, making the top and bottom of the craft level for the battery and possibly a GoPro Hero Session camera.
• There are very few exposed wires or components.
• The ESCs are sealed with liquid tape for some winter fun, hopefully making them not catch fire in snow.
• The weight of the quadcopter is 345 grams without the battery and around 500g with the battery.