Sup3rLite Reborn

By LawnDart on Mar 18, 2018

2  156  0

Retired this frame a while back but after picking up a SuperLite 4" I figured it'd be fun to have matching 3" and 4" quads.

I need to pick up a better VTX antenna and find/make a 3d printed mount for it.

Quad startup tone is Axel F, the theme song from Beverly Hills Cop.


Part List


SuperLight 3 inch (V2)

Flight Controller

Matek F411-MINI Flight Controller w/ F4, MPU60000, BFOSD, BEC 5V (3 builds)


Airbot Ori32 32Bit 25A 2-4S 20x20 4in1 ESC (82 builds)


4 x BrotherHobby Tornado T1 1407 3600Kv Micro Motor3600kv (194 builds)


Team RaceKraft 3045x3 BN Race Prop 2L2R Pink

FPV Camera

Caddx Turbo Micro S2 600TVL CCD NTSC/PAL FPV Cam - Turbo Eye Lens (27 builds)

FPV Transmitter

Eachine VTX03 Super Mini 5.8G 72CH 0/25mW/50mw/200mW Switchable FPV Transmitter (426 builds)


XM PLUS (Mini SBUS Non-telemetry Full Range) (1422 builds)


Tattu 850mAh 14.8V 75C 4S1P Lipo Battery Pack (XT30) (34 builds)


FrSky Horus X10 Radio (Amber)


DJI Digital FPV Goggles - Ultra Low Latency 720p 120FPS Digital HD (87 builds)

HD Camera

GoPro Hero5 Session (267 builds)

Misc Parts


Radio Module

TBS Crossfire TX (10 builds)

Battery Charger

ISDT Q6 Plus 300W 14A MINI Pocket Battery Balance Charger (57 builds)

Soldering Iron

Weller WESD51 Digital Soldering Station
See Site


Lowepro QuadGuard BP X3 - Drone Backpack for 4 FPV Quad Racing Drones and 15" Laptop w/Exterior Mounts (Black) (24 builds)
Show stores (9)


Sign in to comment

Guides & Reviews

28 1,340  11
19 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
43 4,878  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more