Rooster
By ansimation on Mar 22, 2018
My first 5" quad. Used the Armattan Rooster frame around a Bardwell F4. It's quite a difference from the Japalura, lol. I love this thing!
Photos
By ansimation on Mar 22, 2018My first 5" quad. Used the Armattan Rooster frame around a Bardwell F4. It's quite a difference from the Japalura, lol. I love this thing!
Great looking build! I've an almost similar build except for the escs! :)
How is your GoPro footage with this setup? I'm getting some jello in my footage. Have soft mounted my motors and the FC. Have tried using the gopro session armor and also a fixed gopro mount. Both have the same issue.
Thanks! The GoPro footage isnt too bad. I did have a bunch of jello when I was trying to soft mount the GoPro but then I nixed that and just get it as tight as I can with the strap. Between that and switching form the RaceKraft props to some DalProp props, the jello is mostly gone. Of course if you crash or bend a prop then you'll get some too but overall it's not that bad.
Good to know that its gone for you. So I figured out my issue too - I had electronic stabilitzation ON on my session 5! It's recommended to turn it OFF. And motor 1 bell was also bent. I replaced that motor too. With these two changes, jello is gone. I still get some micro vibrations when cruising at lower speeds (especially noticeable close to the ground), but overall much much better than what I had before.
Weird. When I scrol through my Session5 settings, I see image stabilization, but it says n/a and I can't change it.