Osho 210

By thegreen4me on Mar 31, 2018

14  413  4

This drone is based on a frame and canopy I designed myself. With the aerodynamic canopy and the totally unique vibration dampeners at the ends of the arms, this thing absolutely handles like a Cadillac; it just feels incredibly smooth. If I were to build this craft again I would have picked different 1407 motors from a different brand, but with this frame it doesnt really matter since a little bit of power goes a long way when you have these open arms that allow essentially 100% of the thrust to pass through.

Photos

Part List

Frame

Osho 210 Frame Kit
Guruquads.com
$95.00

Flight Controller

OMNIBUS AIO F4 V5 Flight Control (22 builds)
Store.myairbot.com
$29.99

ESCs

Lumenier BLHeli_S 20A 4-in-1 BEC 5V 1.5A ESC DSHOT (3 builds)
Getfpv.com
$38.99

Motors

4 x DYS SE1407 3600 KV Brushless Motor (3 builds)
Fpvheadquarters.com
$51.96

FPV Camera

RunCam OWL PLUS 700TVL 0.0001 LUX FPV Camera FOV 150° Wide Angle F2.0 lens IR Blocked 5-22V (21 builds)
Banggood.com
$44.99

FPV Transmitter

TBS Unify Pro 5G8 HV (SMA) (586 builds)
Getfpv.com
$49.99

Receiver

FrSky R-XSR 16 Channel Receiver (863 builds)
Progressiverc.com
$19.99

Batteries

Thunder Power RC TP870-4SA80X (2 builds)
Thunderpowerrc.com
See Site
Show stores (7)

Discussion

Sign in to comment

Reptile   Apr 06, 2018  
1

Hi, really nice build (especially good job with the frame), what is its fligh time?

thegreen4me   Apr 06, 2018 

Thank you. Flight time with the battery above is about 4 minutes when flying aggressively, 8 minutes when just cruising and doing some gentle power loops. I also have a 2s 2000mah pack for when i just want to enjoy the view from the air, and that one goes almost 20 minutes.

TheMrJahn   Mar 31, 2018  
1

Great build!!!!!! Very cool!

thegreen4me   Mar 31, 2018 

Thank you!

Guides & Reviews

26 1,243  11
17 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
42 4,828  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more