Nanananana Batman 6s

By QuadifyRC.com on Aug 12, 2018

2  347  0

Best way to describe this build is a HGLRC Batman 220 RTF but with low kV motors more suited for 6s than the 2306 2450kV included as stock. Here I've used the Hobbycool 2207 1700kV (A Brother Hobby R3) which is very good value - about $15 each.

My full write up on component choice is here:
http://quadifyrc.weebly.com/racing-quad-builds/6s-low-kv-build-part-1-which-parts-i-have-chosen-and-why
and for the build itself is here:
http://quadifyrc.weebly.com/racing-quad-builds/6s-low-kv-build-part-2-the-build-process

I've maidened on 4s already and have one pack only on 6s. Needs a good tune and I'd like to get ESC telemetry working before I start thrashing it around a bit more. Frame is suprisingly good quality, electronics seem fine and the motors are typical Brother Hobby. My first time using a micro eagle and I'm in love - other than looking good in daylight I did initial FPV tests at night and can't believe how much light it lets in!! Not happy with VTX antenna popping out the top of the frame because it will break - looking for 3d printed solution that hangs off the rear standoffs. Oh yeah, motor wires are long should I wish to transfer to a 7" frame.

Photos

Discussion

Sign in to comment

Guides & Reviews

52 3,881  44
24 days ago

For the longest time we've been limited to 3 to 4 minutes of flight and lots and lots of batteries. With more efficient motors and frame designs it's now possible to push the envelope much further. This guide will walk you through the process of building a micro long range quad capable of flying 8-30 minutes and more than 4km. The build is moderately difficult, but with the right tools and steady hands..

Read more
35 2,599  18
Jul 20, 2020

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more