The maiden was a success. This micro quad rips! Plenty of thrust to make it out of long dives. Flips and rolls like a frestyle quad. Elevation control like a racer. Costs less than a new GoPro, and records in 1080p60! How could you want anything more than this? Might need to fleet this out!
Frame |
Splitshark
(9 builds)
Falconmultirotors.com
|
$35.00 |
Flight Controller |
Flycolor Raptor S 4 en 1 BLHeli-S 30A ESC OSD intégré OSD avec F3 contrôleur de vol pour RC Drone
(3 builds)
Banggood.com
|
See Site |
Motors |
4 x EMAX RS1106 II 4500Kv Micro Motor
(32 builds)
Racedayquads.com
|
$51.96 |
FPV Camera |
RunCam Split Mini 2 Micro FPV Camera / HD DVR 1080P 60 FPS Recorder (M8 or M12 Lens) - Orange
(89 builds)
Racedayquads.com
|
$69.99 |
FPV Transmitter |
Wolfwhoop TX1 5.8GHz 48CH FPV 0mW/25mW/200mW Switchable Transmitter with IPEX Line Antenna Mini VTX
(9 builds)
Amazon.com
|
$10.99 |
Receiver |
FrSky XM+ 2.4GHz Micro ReceiverDefault Title
(1149 builds)
Racedayquads.com
|
$15.99 |
AirbladeUAV has done it again and this time they've brought long range to the 5" class! Based on the popular Transformer Mini, the new Transformer 5" Ultralight adopts a lot of the same design philosophies with larger props and more payload capacity. It can fly upwards of 20 minutes on a 4 cell Li-Ion battery pack and in ideal conditions it's got a range of over 4 to 5 miles. In this guide I'll walk..
Read moreWith the release of the DJI FPV Drone cinematic FPV has become a lot more accessible, but you certainly don't want to crash a $750 drone! The QAV-CINE Freybott is a compact, lightweight cinematic FPV drone that can take a hit and keep going. It's a lot safer to fly indoors and around people. With a naked GoPro or the SMO 4k you can capture some great stabilized footage. In this guide I'll show you..
Read more
That's a great looking frame. Are you not concerned about the camera in a front end smack though? Looks to be sticking out a little more than with most frames.
Thank you! Totally not concerned with the camera getting hit. If you're worried about that, I'd recommend a 20x20 stack and the Runcam Split Micro V2. It will sit back a tiny bit. You could also 3D print a bumper or something but you'd need 2.5" props.