Tweek

By BlueOverBrown on Dec 03, 2018

6  274  0

I transplanted many parts into this one from Comrade, my previous 3 inch build, I was tired of snapping arms.
Notable features are a current sensor built into the xt30 and the buzzer/LED combo I built into the back. I had to trim the tabs a bit to get the buzzer/LEDs to fit between the vertical plates, but it worked.
Unfortunately, I didn't discover VHB until after I had mounted the racewire with zip ties and eletrical tape underneath, next time!
I'm overall very happy with the way it flies, I named it Tweek because of the tiny bit of prop wash oscilation that I can't seem to tune out.

Photos

Discussion

Sign in to comment

Guides & Reviews

29 1,563  11
25 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
44 5,030  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more