Boo Berry

By BlueOverBrown on Dec 27, 2018

3  190  1

This build was tighter than expected. I replaced the stock 20mm standoffs with 28 mm standoffs in order to mount the VTX and Rx on the stack . The stock antenna mount put the antenna in a bad position in my opinion, so I designed a new one. I've found that a dab of E6000 at the spot where the Rx antennas enter the heatshrink does wonders for keeping the antennas in place.
Thingiverse links:
Buzzer and XT60 mount: https://www.thingiverse.com/thing:3271593
SMA Antenna Mount: https://www.thingiverse.com/thing:3296560
Arm Bumpers/Motor Soft Mounts: https://www.thingiverse.com/thing:2993030

Photos

Discussion

Sign in to comment

TheMrJahn   Dec 28, 2018  
1

Great work!

Guides & Reviews

29 1,565  11
25 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
44 5,031  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more