Hey there,
Initially planned to make a 6inch 4-5S cruiser and the option to switch to 5-5,5inch 6S racer/medium range freestyler. But the antenna holder is sticking to far out at the back so the 6inch blade touches it. For now I leave it 5inch mode lol. Also, I used the red FC rubbers from broken down flightone FC's from a friend of mine they are the same fit. I have put some red spacers (standoff's) under it. Also the Caddx camera has been replaced by a foxeer predator V3 because I could not tilt the caddx further up (lens is too wide).
The Immortal T holder comes from a Astrox XS frame but if you scale it 1,5mm wider it will be a perfect fit on the Ghost V2, you only need to cut off 5mm from the bottom up.
Also asked a friend to design a gopro session mount where I could take off the gopro easily and mount it onto another frame. Unfortunatelly it moves a bit too much in the middle but with a tie wrap it's fixed :-).
like it!
Thanks!