The Last Top Mount

By FissionBomb on Feb 14, 2019

10  137  0

I'm not a fan of top mounts but this one was too cheap to ignore. The frame was $21.99 with a $5 coupon on Amazon so I snagged it.

I used Josh Bardwell PCB (w/o stagged pads) on this. Not sure if doing that or extending moto wires would have been easier. ESC powers up and I get tones which is a good sign. What flight controller should I use is my only question.

Picked an SPRacingF3 because it was cheap. Stealing a VTX that has built in OSD from another build.

Photos

Discussion

Sign in to comment

Guides & Reviews

27 2,068  29
23 days ago

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more
25 6,826  24
Nov 30, 2019

In late 2019 DJI made inroads into the FPV scene with their remarkable low-latency digital system. It gave us a 720p video feed with latency on-par with the status quo, analog video. Traditionally we've used analog video systems for low-latency video, but the video quality is far from ideal. It's a trade-off we've been willing to accept for the control. Now we've got the best of both worlds and what..

Read more