This is my first complete build. I wanted a lightweight cinematic drone for carrying an Osmo Pocket.

I designed a custom antenna mount for the micro AXII and Immortal-T V2.
I also designed a custom battery strap mount for the bottom plate, which uses the 30.5x30.5 holes and fits over the stack bolt heads in the 20x20 holes.

The hardest part of this build was getting my Wanhao Duplicator 6 printer to TPU reliably. The key for me was increasing the nozzle temperature to 228C in order to prevent clogs and filament binding.

In order to fit the TBS Pro32 Nano in the WhitenoiseFPV board, I had to file the hole in the board slightly (less than 0.5 mm).

Quad: 252.1g
Battery: 104g
Osmo pocket: 116g
AUW: 472.1g

My only flights so far have been hovering around inside my apartment, but I'm getting 6 minute flight times.